February 2020

BY Neil Currie H ave you ever had a car in with a running fault or an issue, and you plugged the diagnostic tool into the OBD socket then read for trouble codes, only to be met with the message ‘no faults stored’? For many reasons, this confuses technicians and stops them being able to progress with the job. They have no clues or starting point to work from. However, many other tests can be done to find the root cause of the issue. I have worked with many a technician who has been lost after finding a ‘no fault found’ message. I recently had a job where I was able to demonstrate to my colleague how knowing some numbers and how systems work and interlink can help identify what is wrong. Call-out The vehicle in question was a 2012 Land Rover Discovery 4. As we specialise in LR we have built up a good reputation in the area for being able to fix them, having also invested in dealer tooling and information. The customer’s first contact with us was via telephone and he explained he had parked the vehicle up outside his house and then having come to it the next day it would not start. The engine would turn over but it would not fire into life. He informed us his local garage had come out for a look and had been unsuccessful in finding the cause and recommended getting the vehicle recovered to us. He asked our call-out charge and asked for us to come and take a look before he organised recovery. This is not my favourite type of job as with limited tooling there is only so much you can do but we agreed to go and take and look and see what we could find. No fault codes stored Along with my colleague Jamie we went to the customer’s house that afternoon, taking a scan tool and the tool kit in our work van. Once we arrived we spoke to the customer to gather some information about the problem. He told us no recent work had been carried out on the vehicle and the other garage had done some basic tests on the battery and fuel system where it sat but could not find an issue. I sat in the vehicle and cranked the vehicle to verify the complaint, doing this also allowed a few checks to be done by listening to the sound of the engine cranking. A trained ear can pick up a compression issue, whether it is spinning fast enough or anything mechanical which doesn’t sound correct. On this vehicle though all sounded ok. I then let Jamie do some checks to see what he could find. As a younger technician he mainly does MOT and general service work, so it was a good opportunity to possible teach him something along the way without the distraction of a busy workshop. After some basic checks he decided to plug in the scan took and see if any fault codes were stored. Upon carrying out a fault code report he was met with the message ‘no fault codes stored’. I then asked him what his thoughts were and where we go next. His reply was “I don’t know?” I am sure this has happened to some of you reading this article, we have all been there. Live data I explained to him that live data was a key element here and we should use it to our advantage. We need to look for data relevant to the complaint to rule out what it can’t be, and knowing what the numbers mean will do this quickly. Unfortunately, this takes years of looking at good data, taking notes and memorising it. Luckily for him, I was able to assist. My first checks were to be engine RPM, fuel pressure, immobiliser status, cam/crank synchronisation and a plausibility check of all temperature and pressure sensors to make sure they were in spec. Working through them all with ignition on, then cranking everything looked 30 AFTERMARKET FEBRUARY 2020 TECHNICAL www.aftermarketonline.net NO CODES, NO CLUES? Forever the codebreaker, 2019 Top Technician winner Neil Currie shows what to do when there are no codes at all Below: Fig 1